Farmall & IHC Tractors Discussion Board |
Re: Rebuilding Hydra-Touch valves
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dick on September 23, 2003 at 08:17:41 from (65.59.17.103):
In Reply to: Rebuilding Hydra-Touch valves posted by Bill on September 22, 2003 at 17:31:30:
I was dumb enough to ask about that special tool at a CaseIH parts counter, where they were actually nice enough to try to find it - it's apparently not available at this point. As a substitute which actually works, but probably not the first time you try it, get out your socket set and try to find the one about the right diameter - seems like it was about 7/8" or 15/16" - to match the valve. Fiddle with it a bit and you'll probably get it to work for you. Something you might want to consider is whether you really want those garter springs in there at all. Their function is to lock the valve open until the cylinder reaches the end of its travel, and then the valve is supposed to automatically center if some of those other little bitty parts in there are still working properly. It's a nice theory, but it usually doesn't work at low RPMs (not enough pressure to center the control valve), and it's also really not essential for most uses of the hydraulics. Anyway, something to consider. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|