|
Farmall & IHC Tractors Discussion Board |
Belt Pulley Removal C123 engine - Got it ! How to
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RayP(MI) on September 12, 2003 at 13:58:49 from (216.46.209.246):
First of all, thanks to the guys that responded to the previous post. I considered all the answers, and after much stress, and trying several methods, I drilled two 7/16" holes thru the pulley, just inside the shoulder. They came out such that I could insert bolts through the holes, and by grinding off the flat on one side of each nut, things just fit. Placed a deep socket from socket wrench set in the hole in pulley against the end of the crankshaft. A fairly heavy plate across the end of the socket, and tapped to fit the spacing of the bolts, made a makeshift puller. Took several steps, tightening bolts, removing, adding washers for spacers tightening, again.... That pulley stuck tight until the last possible fraction of an inch, but I finally got it off. It did what my 3 jaw puller just wouldn't do! Now, more questions - tried to use the threaded hole in the crankshaft. Couldn't find but one bolt of the proper size and thread pitch to fit in my junkbox. It isn't 7/16, and it isn't 1/2. Diameter of bolt appears to be .471, and 13tpi. But my 1/2" NC die doesn't like the threads! What is it? Now that I have the pulley off, I am looking forward to having to replace it. What's the best technique for getting it back on? If I could trust the threaded hole, and get proper threaded rod I might be able to use that to pull the pulley back on?
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
