Farmall & IHC Tractors Discussion Board |
Stan(VA)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gary_N_WV on September 10, 2003 at 18:22:25 from (69.43.20.73):
Thanks Stan for the governor bearing part number... I have another question, that maybe you can help with. Without measuring it, I'm guessing that the "Speed Change" lever shaft is about an inch and 1/2 long. Where it goes into the housing there is a seal and then maybe a 1/4 thickness of housing, but there are no spacers etc, which allows a lot of end play......I understand that the spring is going to "more or less" hold it in one place, but it just seems like there is "a lot of shaft" with very little support in the middle. I'm just wondering if something is missing from mine. I intended to order a parts manual from Binder Books after I got home from work this evening, but got involved in spray painting my block and and several other parts and forgot. Back to the bearing, I'm going to try "prick punching" the race as Bob suggested. The bearings and other parts look to be in good shape, but 2 of the balls fall out. Thanks for your help ! Gary
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|