Farmall & IHC Tractors Discussion Board |
Re: IH DT436 oil pressure spec?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by oldfart on September 05, 2003 at 02:22:40 from (204.44.243.61):
In Reply to: IH DT436 oil pressure spec? posted by Steven@nd on August 22, 2003 at 19:07:33:
Steve, I have a 1460 also with 5200hrs on motor. Oil presssure on guage in cab is on the low side also. Oil consumation does not show up till we get 50 plus hrs. on change and then it will easily take two quarts in a 10 hr. day. Neighbor was loosing oil pressure in his and the problem was the injector pump was putting fuel into the crankase. He was over 7000 hrs. on his motor. Good motor, look at Johnson Harvesting web site history they had up to 7500 hrs. on the machines not sure on the motor. Good luck
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|