Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: Re: Second generator still
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jacques on September 01, 2003 at 17:40:59 from (208.180.68.32):
In Reply to: Re: Re: Re: Re: Re: Re: Second generator still no posted by Bob Quale on September 01, 2003 at 06:43:30:
Bob, someone may have mentioned this already, but here goes. Make sure the wires to/from the gen/regulator, etc., are not splice with crimp-on splices. These are ok for a while if done properly, but the best connections/splices are soldered! If you've got a few old crimp-on splices in your generating or ignition wiring, replace them. Also make sure you've got the right size wire for the job. Just one or two old, corroded or improperly done splices will be enough to drop voltage, overheat and maybe even cause a fire. After you fix the generating problem, recheck the wiring and replace any wire that's seems questionable. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|