Farmall & IHC Tractors Discussion Board |
Re: H clutch pilot bearing (ideas)?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JB on August 27, 2003 at 17:28:00 from (24.157.142.242):
In Reply to: H clutch pilot bearing (ideas)? posted by Kelly C on August 27, 2003 at 16:28:49:
Hi, never worked on a H but have done SC and many newer models. Is it a true bearing or just a bronze bushing like the SC ? To pull a regular bearing I would remove one of the claws from a regular bearing puller and insert it into the shaft hole, then clamp a visegrip on the other end and hit the visegrip with a hammer. Rotate the claw in the shaft hole to keep the bearing coming out straight. For the bronze bushing on the SC, used a broken hack saw blade to make 3 cuts in the bushing and then used a small chisel or screw driver to wedge between the flywheel and bushing. The bushing should break at the hack saw cuts and colaspe inward. Good luck. Jb
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|