Farmall & IHC Tractors Discussion Board |
Re: Re: Re: clutch clearance question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JB on August 11, 2003 at 18:03:51 from (24.157.143.182):
In Reply to: Re: Re: clutch clearance question posted by Diana on August 10, 2003 at 16:36:57:
Hi, it has been 40 years since I worked on 300U. I believe there was an inspection hole on the bottom of the bell howsing/torque tube that would allow you to see the pressure plate/release bearing. With the tractor idling and in neutral and brakes locked you should be able to see if the release bearing is turning or not. Is there grease fittings on the release bearing carrier assembly or has my memory of 300U become muddled with JD 420 that we owned at the same time ? Great tractor the 300U, would pull a 17 tooth spring tooth harrow in heavy soil in 4th direct drive. The only down fall was the small gas tank and you had to fill it 3 times a day. JB
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|