Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Position of Tool Box for H and M
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by GP on August 06, 2003 at 13:11:45 from (167.68.0.67):
In Reply to: Re: Re: Position of Tool Box for H and M posted by JohnG(TX) on August 06, 2003 at 12:55:41:
Off hand I don't remember the notch being off center for the light bar mounted tool box. You should be able to hold the tool box up to your light bar and see if it fits. If it is a light bar mount it requires 4 mounting brackets. That attach to the front (side with the notch) of the tool box and then slide over the light bar and tighten down. These brackets would be easy to fabricate.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|