Farmall & IHC Tractors Discussion Board |
Re: Checked out the 460
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dvtw on July 31, 2003 at 09:06:34 from (136.205.16.3):
In Reply to: Checked out the 460 posted by TC on July 30, 2003 at 12:55:34:
I went through splitting the manifolds on my 560 just recently. A machine shop can do it. I had to go through 2 however...the first broke the old exhaust manifold to pieces getting it off (I told them they could as it had a 1 inch hole burned in it that was unrepairable) and gave it back to me. Said they were afraid to go farther. No charge. I took it to a better shop and they finished the job and put new studs in for $25. I thought was a good deal. Bought a used manifold for $80. A gasket for around $18 and it sounds and works great. The bushings in my heatriser were gone. I just welded it shut to seal it from leaking. It may take it a little longer to warm up in the winter but oh well. Goodluck if you go for it.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|