Farmall & IHC Tractors Discussion Board |
Re: Farmall A Questions from a Newbie
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Shaggy on July 27, 2003 at 19:48:30 from (12.215.126.164):
In Reply to: Farmall A Questions from a Newbie posted by Bob B on July 27, 2003 at 19:17:14:
Hello and good score on the A. The 2 Lshaped arms are for checking the oil. As for the crank, the way I have mines is with the handle going down along the clutch pedal I am not sure if its right but it works.The mag switch sounds wrong,it should have a 1 post switch or a grounding tab on the mag itself.The bracket?no clue.the oil pressure should have a Low or High low being in the red.The serial number tag should be on theseat bracket next to the trans.And a half a turn of play isn't to bad. To tighten it you may have to drop the front axle and try to tighten the bolt on the pitman arm. I may not right on all of this but I close. Have fun and good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|