Farmall & IHC Tractors Discussion Board |
M , back end noise (crownwheel pinion setup)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by mike on July 26, 2003 at 14:46:08 from (12.129.244.88):
I changed the rear gear housing on my M as it had been repaired at some stage of its life and still had many cracks through it. I measured the backlash on the crownwheel as 55 thou. When I assembled the gears in the new casing although the book says 12 thou. is the correct figure, I put it back with approx 35 thou backlash. I also cut the last 3 shims that I put back in both sides to enable easy acess to do quick adjustments if necessary. Although the gearset in the old casing ran nice and quiet, they now sound like a fire siren, and scatter the livestock for miles around. I've moved some of the shims across to open up the backlash to no avail. I've been told that to set up the crownwheel and pinion as per the book would be a waist of time as they need to run in exactly their old position. Anybody have the answer?
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|