|
Farmall & IHC Tractors Discussion Board |
Re: 544 Gas tractor conversion to deisel
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by K.B. on July 12, 2003 at 17:46:28 from (209.163.43.42):
In Reply to: 544 Gas tractor conversion to deisel posted by Ron on July 12, 2003 at 11:33:41:
Not a bad idea at all. Right now you have a C-200 gas, they have a reputation for being gutless and real touchy about carb ajustments. It's a sleeveless engine besides, so you have to bore it to the next oversize if you replace the pistons. The switch to diesel shouldn't be too bad, but like any re-power, it will take some work and a little engineering. The engine you need is the D-239 four-cylinder German diesel. This engine was found in the 544, 574, 664, 674, and 684. You will also need the throttle linkage and fuel tank from a 544 Diesel, or you'll need to add a fitting to your existing tank for the fuel return line. Radiator might be different, too. It will go easier if you get frame rails from a 544 Diesel. If you get the engine from anything other than a 544, the oil pan and rear engine plate will be incorrect, the 64, 74 and 84 series (those were all British-built Utilities, 544 is American-built) had a cast oil pan that the front end bolted to, the Farmall 544 Row-Crop had a stamped-steel oil pan, not sure what the International 544 Utility had. Do you have a Row-Crop or a Utility? Since there are so many small differences between the gas and diesel, the easiest way for you to go might be to find a 544 Diesel parts tractor in a salvage yard. The D-239 is one of the best IH engines there is in terms of fuel economy, reliability, and very long life. We have three tractors, 826, 786, and 3088, with the six-cylinder version, the D-358 German diesel. The 826 and 786 both have almost 8,000 hours on them and have never been touched, and still run as well as the 3088 which only has 1800 hours. Someday I'm going to find myself a Farmall 544 Row-crop, gear drive, diesel. If you have any questions as you swap engines, just ask!
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
