Farmall & IHC Tractors Discussion Board |
Re: Super M clutch sleeve disc installation
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kiwi BM on July 12, 2003 at 03:52:06 from (202.27.176.157):
In Reply to: Super M clutch sleeve disc installation posted by George E. on July 11, 2003 at 13:00:29:
I replaced the clutch and pressure plate on my Super BM this past week. Suggest you check these; 1) is the clutch plate around the correct way. The circular dust cover should face forward. 2) have you tightened down the fingers on the clutch pressure plate. You do this by inserting three of the holding bolts into the rear of the pressure plate. Tighten them up (as you did when you removed the pressure plate) and once the pressure plate is bolted in place then remove them allowing the fingers to open.Those three bolts then become complete the holding of the pressure plate in place. 3) Lastly try to insert the clutch plate, pressure plate all on the shaft and then ensure the shaft is located correctly.We found doing it this way we had no problems with setting it up. We had a little juggling match with this lot, but we got the whole lot back in place and it works. There is an excellent contribution on this website I printed of on changing and M clutch and we followed it the letter. But sorry I cannot find it this evening.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|