Farmall & IHC Tractors Discussion Board |
Re: 1943 M... how many made?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Perry on July 09, 2003 at 20:35:23 from (205.188.209.140):
In Reply to: 1943 M... how many made? posted by Jeremy on July 08, 2003 at 13:24:38:
Look at the casting date on the drive part of the wheel. Not the rim but the heavy casting that the rim bolts to that drives the outer rim. I am referring to the two piece wheel assembly, ie. the heavy casting drive wheel and the separate 10 or 11 inch rim. If yours matches the 43 date then you know it most likely came with rubber on it. The fact it has rubber today doesn't mean a lot until you check it out. If it is a wheel other than I described then you have to go further. This will logically confirm that yours may/maynot of had rubber originally. I have a 1940 and the drive part of the wheel has a Dec. 39 casting date on it which is close to the other casting dates on the tractor, so I conclude it came with rubber. Now to your question, how many. Most folks will say 2 to 1 came with steel during the war. Cost was a big factor as well as the restrictions or availability of the rubber. The war started in 42 and cost was probably the greatest factor prior to 42 then restrictions on rubber plus the cost was the issue during the war but probably restrictions on rubber as that was a big deal. Now at the same time food was extremely important and who knows how many M's that had to haul the wagon to town to deliver got rubber wheels. M's didn't get road gear for no reason and road gear means rubber tires. And as Guy says it is probably impossible to determine how many had one or the other but it is fun to speculate.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|