Farmall & IHC Tractors Discussion Board |
Re: Raking hay and my H manifold...
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by FC on July 03, 2003 at 11:16:10 from (66.84.205.26):
In Reply to: Raking hay and my H manifold... posted by Brent in IA on July 03, 2003 at 10:29:15:
There have been several discussions on the rusty manifold/pipe threads on here in the past and someone mentioned getting a new pipe already threaded and cutting across the threads (I believe using a hacksaw) so it will basically chase out the threads on the manifold. Another solution would involve getting a thread chaser such as a plumber might use to clean the threads on the manifold. I believe the new pipe trick might just give enough bite to do the trick if you are careful and be sure and lubricate it while threading it in. Someone else might have another suggestion. Welding it is another option, but not very friendly should you ever want to remove it in the future. I believe you can use 2" pipe with a tapered thread (pretty common). Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|