Farmall & IHC Tractors Discussion Board |
Re: Will an SA grader blade fit on an A?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chad Penny on June 23, 2003 at 10:31:02 from (152.72.252.244):
In Reply to: Will an SA grader blade fit on an A? posted by Doug in NJ on June 23, 2003 at 09:58:39:
I have a super A blade on my 1940 A and it has the same levers you do mine are spring assited. You can use that blade and yes with some minor changes in how you hook it up to the spring assist levers you can make it work fairly easy. yes it is a lot nicer to have HYD's like on my cub and the cub blade but you do what you can. As for lifting up and down it is easy. with the spring assist set right it is very easy to move the blade. I even saw one time where the front blade had the correct mounting for the A so it must have been made by IH. anyhow we also have a 60" mower deck for our A and use the same spring assist and it works good. I say go for if you have the ability or a friend that can help you fab up your lifting part. just my $.02 worht! Chad
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|