Farmall & IHC Tractors Discussion Board |
Re: IH Farmall 140 Bumper Grill Guard
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on June 17, 2003 at 11:21:42 from (209.226.247.173):
In Reply to: IH Farmall 140 Bumper Grill Guard posted by G.Rainey on June 15, 2003 at 05:08:14:
I think any of these you have seen are local fabrications. I have one that serves a dual function. I hang a Gandy applicator on it for N applications in my garden. I put two drop links on those two tabs behind the square hole for cultivator lift frame. From there I have two 3" chanel boxed in with 3" chanel. This is low enough so axle will not touch when osculating. The up rights on front are 1.25" square tubing. I have two cross members of the same and angle iron across top. At the back I have a brace out of 1/2 x 2" flat bar going to 5/8 hole on clutch housing near starter. I also plan to build another one of these a bit heavier to mount a remote cylinder for lifting my front blade. My blade is currently lifted by hydraulic rockshaft the factory way. I find putting load of a blade on that creates leaks in the touch control in time. I have had my blade on three separate tractors and each one leaked with blade.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|