Farmall & IHC Tractors Discussion Board |
Re: cover over rear engine bearing cage on F-30
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Okla/Kans Bill on June 12, 2003 at 19:23:15 from (209.240.198.63):
In Reply to: cover over rear engine bearing cage on F-30 posted by okla/kans Bill on June 12, 2003 at 16:42:40:
hey heretrythis. Ok I agree the gasket probably was made of paper, and I can do that, BUT what was in the groove that the paper coveredWith the paper over the face of the groove on the bearing cover the only way for anything to exit or enter, (if there was nothing in there in the first place, was from the notch on the flange of the inside of the groove. The groove is about 1/2in deep and wide set inside an inch or so from the inside edge of the plate covering the bearing cage. And no, I aint wanting to save the bearing, but the housing arouund it is what im bolted to, and my I & T manual says it all comes out as an assembly the bearing and housing. which makes me think the bearing is put on fro the inside of the housing, but I dont know that
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|