Farmall & IHC Tractors Discussion Board |
Re: Farmall C timing adjustment
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Randy in NE on June 12, 2003 at 09:53:44 from (216.58.237.20):
In Reply to: Farmall C timing adjustment posted by Steve Kuehster on June 12, 2003 at 09:22:43:
I have not looked for the timing mark on mine. It is supposed to be on the front pulley. From what I remember reading in previous posts it is pretty hard to see. Growing up we always just timed them by ear. Loosen the locking bolt and slowly rotate the distributor one or the other until it runs the smoothest. It would be a good idea to do this again at fast idle. Also verify that it revs up approriately. P.S. If the plug wires are dried and cracked it is not unusual to get bit pretty good if you try grabbing the distributor cap. Been there and done that.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|