Farmall & IHC Tractors Discussion Board |
what cmes off after the flywheel on 30
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ola/kan BILL on June 11, 2003 at 18:47:17 from (209.240.198.63):
Do I take the little blts off the ring around the hole that they flywheel hup went in or what. Need some help[ please. Since the bearings gone, what if the wicks gone that lubricates it. How can Ibe sure in replacing the bearing that the wick (if there) is in the right place, and if its not there, what place is the right place. Where is the seal in relation to the bearing. infront (toward the engine) or behind. Figure IH35, page 13 shows a puller using somthing that looks like its threaded and if so probably screwed into the crank shaft. Wjat cam I get thats that size?
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|