Farmall & IHC Tractors Discussion Board |
Re: Clutch replacement on Cub LoBoy
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Sharky on June 11, 2003 at 05:55:13 from (199.196.144.11):
In Reply to: Clutch replacement on Cub LoBoy posted by IH Since Birth on June 10, 2003 at 17:33:12:
Very simple, Be sure to have a pilot tool, or some other way to align the spindle to through the clutch plate as it is made of thin spring steel and can be broken in not aligned properly when putting the two halves back together, also go the Carter & Gruenwald and buy the throwout bearing that is the true bearing (not the graphite one like the original), Check the fingers on the pressure plate also, very common to break these off, Might as well replace the pressure plate too, it's not that expensive and will save you from having to do it again.....
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|