Farmall & IHC Tractors Discussion Board |
Re: Re: Help mounting a planter to a Farmall A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chad on June 09, 2003 at 11:36:57 from (152.72.252.244):
In Reply to: Re: Help mounting a planter to a Farmall A posted by Greg Miller on June 09, 2003 at 10:47:25:
I have one for a Farmall cub and they are very similar. It bolts to the torque tube on the drivers side and has a cahin that goes back to a gear on the driver side bull gear housing. then there is a underslung planter part that puts the seeds in the ground then covers them up and on my cub it kind of hooks into where you hook your culivator. then a tube goes from the seed hopper to the underslung part. I can show you some pictures on the link below but in the pictures it only shows the hopper and not the underslung stuff. hope that helps some. Chad
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|