Farmall & IHC Tractors Discussion Board |
Re: F-12 Mag
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on June 08, 2003 at 11:43:43 from (63.147.130.30):
In Reply to: F-12 Mag posted by shank on June 08, 2003 at 09:12:35:
When doing the bench test, you say you grounded the plugs to metal. Was they grounded back to the mag? If not, I would think that it would effect the test. Be sure you are grounding to mag or to something that leads back to the mag for the test. No, that doesn't sound like good enough spark. Shouldn't have any trouble seeing it jump the gap in the plug. The magnet can get weak. Never experienced a weak magnet problem myself but you can strengthen them back up if you have the equipment. You say it is getting gas, are you sure it is getting the right mixture of gas. I have blamed mags myself a couple times for problems over on the fuel side.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|