Farmall & IHC Tractors Discussion Board |
Re: 25V/27V IH mowers
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on June 06, 2003 at 16:58:14 from (64.228.11.49):
In Reply to: 25V/27V IH mowers posted by Not Green on June 05, 2003 at 12:08:35:
My dad had one, and for some reason I believe it was a 27, not sure but that rings a bell. His mounted either on standard drawbar of 130, H or 300. On the 130 the rod went between the left fender and tire to the hydraulic rockshaft on the touch control of 130. He used a different rod going to a hydraulic cylinder on the other two. The set up for Super A or 130 was factory. The other set was locally fabricated and used implement cylinder from disk harrow. I am not saying IH did not have a factory set up for H, M, 300, etc. That same mower could be used on a C, SC or 200 by using an H type drawbar and hooking to touch control for lift. We had a neighbor with that set up on a Super C.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|