Farmall & IHC Tractors Discussion Board |
Re: IH 606 3-point hitch
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on June 04, 2003 at 18:32:17 from (64.228.14.97):
In Reply to: IH 606 3-point hitch posted by Bill C on June 03, 2003 at 12:50:40:
Bill: I wish you had a picture of that hitch to post. I have never seen a 606, however I'm thinking that hitch should be same design as other 04 and 06 tractors. Both those vertical lift links should be the same. They should both have levelling cranks. I'm not just sure what you mean by Y type. The ones I remember had about 1" pin going through rockshaft with a hole on the end at right angles to pin. The levelling crank and lift link attached in that hole on head of bolt. I am not sure this will make sence to you as it's hard finding the right words to put on it. One place where a picture would be worth a 1000 words. Come back with your comments, I'm sure we can sort this out.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|