Farmall & IHC Tractors Discussion Board |
Re: Super C Questions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan on June 03, 2003 at 17:46:12 from (66.230.21.180):
In Reply to: Super C Questions posted by Anthony P on June 03, 2003 at 14:01:48:
Don't buy anything except oil and filters for it at napa. when I was rebuilding my engine I tried to go cheaper and got all new valve parts from napa. springs, valves, guides, keepers, and also some con rod bearings. The rod bearings were the only thing that fit. Guides were too long and too big on the od. springs were way too long. They bound before even getting close to max lift. keepers were wrong size. Stay with IH as much as possible. Mail order if you have to. We double and tripple checked all the numbeers and my engine to make sure the right stuff was ordered and it was correct. I have the c-123 with original firecrator pistons. Napa did have good ignition parts for mine but In my opinion IH parts are better and last longer.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|