Farmall & IHC Tractors Discussion Board |
Re: Farmall M Belt Pulleys
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on May 30, 2003 at 10:40:08 from (63.147.130.18):
In Reply to: Farmall M Belt Pulleys posted by Bud on May 30, 2003 at 06:28:29:
One idea might be that the paper pulley would be less likely to slip versus one made of metal (just a guess). Paper pulleys are really made of moreless layers of paper pressed together and then riveted. I have a paper pulley and a metal pulley. The metal pulley is larger in diameter than the paper pulley. Makes me wonder if the paper pulley was the standard pulley, and the metal pulley was for running a hammer mill or something (more so than something to do with years). I haven't had any trouble using the paper pulley or problems with it wearing out. Here's something about the paper pulley's though. They don't take much of that sitting out in the rain. Just a short couple or three years of that, and they won't be any good. You might watch out for deterioration when buying one.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|