Farmall & IHC Tractors Discussion Board |
Re: Cleaning Air Bath Filter Mesh on a '47 H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by rustyfarmall on May 30, 2003 at 09:21:37 from (207.32.13.212):
In Reply to: Cleaning Air Bath Filter Mesh on a '47 H posted by Dave in CT on May 30, 2003 at 08:56:19:
I remember working on an M years ago where I was able to pull all of the mesh out and clean it, but that does not seem to be the case with the H's and M that I have now, I suspect that the one that could be taken apart had already been modified (butchered) so that it could be cleaned. The best way I found to clean one is to have it off, put the cup on, and fill with solvent or whatever, then shake it, you will have to cover the inlet with your hand to keep the solvent in, might want to do this a couple of times, but a lot of crud will come out, then dry it with compressed air, if it doesn't seem clean enough, do it again.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|