Farmall & IHC Tractors Discussion Board |
Re: how do i adjust the valves on my 460D???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RO on May 29, 2003 at 20:46:29 from (24.124.48.58):
In Reply to: how do i adjust the valves on my 460D??? posted by Jason B. on May 29, 2003 at 16:15:36:
Someone on this board told me to set #1 piston at TDC, by aligning the mark on the crankshaft front pulley with the pointer--this is viewable from the left side of the engine looking past generator. With #1 at TDC, valves 1,2,3,5,7 and 9 can be adjusted to 0.027. Then, putting #6 at TDC, you can adjust 4, 6, 8 10 11 and 12. It took me a while to think it through, but to get #6 at TDC, simply requires a 360 degree rotation of the crank pulley from where it was located when #1 was at TDC. I had set the valves on my 560 D prior to learning this and so I went back and rechecked all of mine, adjusting them to with this approach. All worked out fine. I rechecked them with the engine at operating temperature and all is fine. I really appreciated the gentlemen giving me the help and am glad to pass the information on to you. Mine was a 560D, but expect your's is similar.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|