Farmall & IHC Tractors Discussion Board |
Adding dual remotes to H hydralics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kelly C --- the hydralics idot. on May 17, 2003 at 19:29:39 from (63.171.43.140):
Ok guys. For some reason I cant visualize how this is done or if it can be. I would like to add a remote system to my H. This would be a line from the lift all. to the remote. then a line back to the bottom of the lift all. ( the lift all would pump all the time. Same as Steven@ND has. Then I would run 2 lines to my 3pt hitch (when I get it) To give up and down pressure. This much I can visualize. The problem is my loader. it is single action. IE it needs to drain back into the hydralic system using its own wheight. Can this be done? If not maybe there is some kind of splitter valve that I could run the 2 single action. I dont know.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|