Farmall & IHC Tractors Discussion Board |
Re: Ring Pinion
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on May 17, 2003 at 02:02:51 from (216.208.58.110):
In Reply to: Ring Pinion posted by Red Rider on May 15, 2003 at 20:00:08:
Red: I don't have an answer to the direct question you put fourth. Have you looked at the possiblity of using rear end parts from a 560. I don't know if that will work either. I'm just looking at the fact 400 and 450 turned around 1400-1500 for 540 pto and the 560 turned 1800 for 540 pto. I never had that much experience with M, 400, 450, etc. I did have a 560 diesel and in 5th gear they would closely follow my 560 turning at 2,000 rpm so I'm thinking they must be a bit higher speed in gears at some point. The other item I noticed over years is my 560 was slower in reverse, 1st and 2nd than 300 or 656. From there on up I didn't notice a whole lot of difference. These are just some observations, not hard evidence as my neighbor may have had his M turned up in rpm. Never really did an exact comparison on any of those speeds mentioned. Just thoughts that may be worth checking.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|