Farmall & IHC Tractors Discussion Board |
Re: H liftall
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scott Swanson on May 13, 2003 at 08:16:18 from (209.180.31.9):
In Reply to: H liftall posted by jeff in pa on May 13, 2003 at 06:50:16:
Pull the Belt Pulley assembly and check the input shaft for wear and play. The pilot bearing and seals are easy to replace and will improve the health of your tractor. Disconnect the Clutch drive shaft from the tranny coupling and remove the cap crew that holds the coupling in the tranny shaft. A worn pilot bearing is easy to see by removing the belt pulley assembly and wiggling the gears. The 4th/5th sliding gear is right there to inspect. Be sure to dump out the accumulated water in the belt pulley assembly and remember to add additional oil when you replace it. You might want to replace the upper and lower oil seals on both the input shaft and the countershaft. Be careful taking off the nut/driver that spins the belly pump. I had to use a pipe wrench and a high lift to get mine off.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|