Farmall & IHC Tractors Discussion Board |
Hey, Charles -- Re: Electrall thread below
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wardner on May 05, 2003 at 11:23:08 from (63.159.177.110):
There is not much you can do with the Electrall unless you have a gear box. The MTA through 660 uses a constant mesh mid-mount gear box that drives off the IPTO gear behind the main tractor clutch pressure plate. Smaller tractors used a step up gear box bolted to the Electrall. These were all driven by rear PTO. Some were two point mounted and some were trailer mounted. At the left of this page click on "Tractor Photos" and "Implement Photos" and type in "Electrall". There will be a few pictures. I have an original manual that I can scan and email to you. You should also do a search on the Farmall Forum for many posts relating to Electrall. If you are near Eastern Massachusetts, you are welcome to look at my original F400 set-up.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|