Farmall & IHC Tractors Discussion Board |
Re: SMTA Clutch
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on May 05, 2003 at 02:35:52 from (216.208.58.164):
In Reply to: SMTA Clutch posted by Ernie Bob on May 04, 2003 at 22:38:30:
Ernie Bob: Not sure I will be much help. I remember problems in putting 300 together much as you describe. You can line your clutch splines up truning the flywheel, but if your pto spline lining up to the presure plate is not right in relation to drive line spline then you have to engage the pto and line it up by turning the pto shaft. I used a small punch through hole in pto shaft. Problem here is presure plate isn't going to let those change in relation to one another. This is either a two man show or a lot of trips back to pto shaft. As to why your clutch will not release, you may have damaged something when that popping sound occured letting it go together. Or you may have done as I did last year with my Farmall 130. I got in a hurry and put the clutch disc in backwards.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|