Farmall & IHC Tractors Discussion Board |
Re: a temp gauge stays on cold ?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by t4mike on April 30, 2003 at 21:24:28 from (66.11.101.6):
In Reply to: a temp gauge stays on cold ? posted by JONATHAN MIRGON on April 30, 2003 at 13:50:37:
the c-123 pu in my crawler would always run cold, kept diluting the oil with condesation because of it. i messed with the thermostat 5-7 times before i realized the one i got from c/ih was slightly thiner than what the retaining ring holds tight. it had about 1/32 up and down play- just enough to let the water bypass it. i cut some alum coil stock for shim and siliconed it in between the stat seat and the retaining ring so the stat can't lift. put water in it and it warmed up to perfect range and has been for 3 years now. check your stats so there is no up and down play, esp on that c with its 123 engine.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|