Farmall & IHC Tractors Discussion Board |
Re: 460 transmission stuck in gear help!!!!!!!!!!!!!!!!!!!!!! please
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Aces on April 30, 2003 at 09:05:57 from (205.187.82.10):
In Reply to: 460 transmission stuck in gear help!!!!!!!!!!!!!!!!!!!!!! please posted by big red 1 on April 30, 2003 at 08:51:19:
On a 460 the gear shaft lever is in a tower that can be removed wtih three 3/8 bolts, remove them and remove the tower, I think you will see the end of the shaft lever warn bad and that will let the lever drop a fork before the gear is clear out and move another in gear. Use a screw driver and line up the notchs in the forks and put the tower back on. and make sure you shaft slow untill you get it home then you can remove lever again and weld up the end and grind it back down like it should be should look like a ball front to back and flat on both sides just wide enough to fit fork.You will need to adjust the clutch and TA linkage if it has a TA if not adjusted right they will hang in gear and shaft hard.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|