Farmall & IHC Tractors Discussion Board |
Re: Cyclo vs plate
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steven@nd on April 29, 2003 at 20:57:53 from (12.23.185.129):
In Reply to: Cyclo vs plate posted by Mark in WI on April 29, 2003 at 19:22:03:
We have an old 400 and it works great. Sometimes it will throw 2 seeds, but that's because the brush needs replacing - doesn't happen very often. Also, our disc openers are worn past spec, the firming points are not that great either, but it sure raises nice corn yet!! We bought ours for $1000 a couple years ago. Probably put about $100 in repairs so far with 250 acres seeded. You will like the single hopper to fill on the cyclo, and the accuracy is very good also. One thing to mention is that our 6 row takes at least 50 horsepower to operate. I tried it with the SMTA last year and had to run in 2nd gear and that was a load. 544 handles it well.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|