Farmall & IHC Tractors Discussion Board |
Farmall F-20 magneto timing-
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andrew on April 24, 2003 at 23:43:56 from (207.140.80.179):
I played around with the timing on my F-20 for about a week now, On the flywheel I have an "O" then a line and the letter "E" stamped below it. This is the only mark I can find. If I setup the timing according to what the manual says, retarding the spark and then set the mag so the points are just opening, it comes out so the engine is firing before TDC when the spark is supposed to be retarded. I did make sure the #1 cylinder was on TDC and I made sure the mag was at terminal #1. Has anybody else seen this? So, can anyone that has an F-20 tell me this: with the mag retarded, do the points "just open" right at TDC or slightly after? The engine does run, but I still don't think the timing is where it should be.
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|