Farmall & IHC Tractors Discussion Board |
Re: Farmall F-20 timing
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on April 24, 2003 at 12:30:50 from (63.147.130.62):
In Reply to: Farmall F-20 timing posted by Andrew on April 21, 2003 at 14:40:31:
The timing marks are located in the hole of clutch housing when at TDC. I have never been able to see those marks. I always find the TDC the old fashioned way. Find the compression stroke of #1 cylinder and then run the piston right up to the top of stroke. Much easier to do with all the plugs out. I just take mag off at this point. Put a wire or nail in (I'm not sure which one) one of the oil ports on the front of mag. You can in-activate the impulse this way. Put the advance all the way down (in the run position). Rotate mag until the points just open on the number one plug. In this postion is how the mag needs to be bolted to tractor. As mentioned by others, you may have to unbolt the coupler thingy mergiger and rotate a hole or two to get everything lined up. After you get mag bolted on, remove the wire or nail from impulse, finish putting tractor together, adjust the spark advance on mag to the start position, and you should be able to crank it up. Ounce it is started, lower the advance to run position. A gasoline engine that is timed correctly should fire slightly before TDC. Since you have a mag with an advance, this would be in the run position.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|