Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Farmall F-20 timing
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave on April 23, 2003 at 02:54:46 from (216.42.122.30):
In Reply to: Re: Re: Farmall F-20 timing posted by Andrew on April 22, 2003 at 05:03:04:
The flywheel should be stamped DC.If you look in the hole with a strong flashlite you should see a pointer about 9 o'clock position, this is what to line up the DC with.If you take all the spark plugs out and turn the hub on lower crank pulley with big set of channel lock pliers while watching in hole for the DC you can do it all by yourself.Knock the guts out of an old plug and adapt a whistle or put a long piece of plastic tubing into a jar of water to watch fof bubbles.A compression gauge is easiest if you have some help.Nobody ever seems to be around to help when I want to do this procedure. Good Luck!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|