Farmall & IHC Tractors Discussion Board |
Re: 230 With Pipe Loader Won't Fully Bleed, Why??
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gordy on April 22, 2003 at 08:25:54 from (208.42.78.27):
In Reply to: 230 With Pipe Loader Won't Fully Bleed, Why?? posted by Drizler on April 20, 2003 at 18:07:41:
i reread my suggestion and realized that i missed a step and probably wasn't as thorough as i should have been. after step 3 i should have said to be sure to put the control lever in neutral(shutting the tractor off wouldn't be a bad idea either). i had my setup in mind where i wouldn't be near the cylinders when i run the contols but brent makes a very good point on safety. there is no reason that you need to be near the cylinder when you bleed it. it's not necessary to bleed the system like you would bleed the brakes on a car where you have to capture the pressure. also with the control, the idea is to move fluid by "bumping" it, not to build up pressure. not only is there a danger of a high pressure leak but there is also a loose fitting that could be blown out of the cylinder. hope this helps.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|