Farmall & IHC Tractors Discussion Board |
Re: how hot is a 400 engine supposed to get
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve - IN on April 21, 2003 at 21:18:49 from (12.222.17.59):
In Reply to: how hot is a 400 engine supposed to get posted by Bryce Andreasen (Magnum) on April 21, 2003 at 20:02:27:
Wayne has it basically right on the boiling numbers. Add about 3 degrees for every pound of pressure on the cooling system. Deduct about 1 to 1.5 degrees for every 1000 feet above MSL or 14.7 psi air pressure. With an old engine and no oil cooler, you probably won't want to run over 200 degrees water temp, as Wayne said. If you are, you should clean the clean the chaff and dirt from the outside of the radiator and also flush the cooling system with something caustic enough to put a dent in all the rust and crud that has built up in there over the years. Just cleaning it will do more than any other low buck trick will increase the heat exchanging capability of the cooling system.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|