Farmall & IHC Tractors Discussion Board |
Re: IHC 400 Torque
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Rider on April 20, 2003 at 19:21:19 from (66.248.104.83):
In Reply to: IHC 400 Torque posted by adam on April 20, 2003 at 17:51:07:
Adam, usally when the TA goes out it is the overrun clutch (ramp and roller assembly). Your TA clutch could be slipping but that is usally not the case. I have replaced the ramp and roller assembly on all three of my tractors to the heavy duty sprague overrun clutch. You can have your present TA rebuild with the sprague unit by Richard M. Bednarski, 215 Buffalo Rd So., Washington, Pa 15301. Phone # 724 345-3546 or 800 832-6350 in the evenings. I replaced both main and TA clutch, pressure plate, throw out bearigs all seals and gaskets plus had Richard rebuild the TA with Sprague overrun clutch for $892.00 Once you split your tractor you usually don't want to have to do it again.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|