Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: Super-A transmission capacity
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on April 16, 2003 at 13:03:24 from (12.212.25.99):
In Reply to: Re: Re: Re: Re: Re: Super-A transmission capacity posted by Hugh MacKay on April 15, 2003 at 10:03:59:
No as the plate that blocks off the area where the pulley assy would cover up this passage. If i am going to use a belley mower i will take the assy paart as lots of times found the passage either blocked or partially plugged and with the pulley on the mower running under load good lubrication is important. In our area the belt pulleys were used as a lot of feed was ground.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|