|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: Re: Re: Re: BIG BROTHER IS WATCHING--EVEN HERE
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on April 10, 2003 at 16:47:10 from (216.208.58.146):
In Reply to: Re: Re: Re: Re: Re: Re: Re: Re: BIG BROTHER IS WATCHING--EVEN HERE posted by RAS on April 10, 2003 at 08:05:30:
RAS: I don't have a 7220, I just wanted your responce. The last new iron I farmed with was a 1066. However, the reason I chose the 7220 is a friend of mine did in fact have that precice problem. Those computer readings never did solve the problem. They took a computer from another tractor and bingo it worked. I was at the dealers the day they solved this. It was not only dealer technician stumped but 2 CaseIH technicians sent to solve this. Dealer technician wanted to install computer from the other tractor 5 days earlier. A man would need to have rocks in his head to farm with this kind of junk, and I include all makes. I was never without my 1066, 656, 560, 300 or 130 for 5 days during busiest time of year. Or my 100 hp Deere or my Case uniloaders. The Deere, the uniloaders, 1066, 656 and 560 each saw a 1000 hours per year, added to tach. For the price you charge for those tractors today, they should go to work even when the operator is laid up for 5 days. I will give you the benefit of doubt as I believe you were going to give me an answer. Now I would apreciate very much if you could tell me what I have found in my 140 wiring harness on page 1. I will thank you kindly in advance.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
