Farmall & IHC Tractors Discussion Board |
Uh-oh, coolant coming out of the head
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave in MN on April 06, 2003 at 13:57:39 from (205.188.209.78):
As most of you have seen, I got my tractor running after a rebuild this morning. Only ran it for a few minutes when I noticed coolant coming out of one of the nuts holding down the head. I torqued everything down again and started it real quick, but coolant is still coming out. Obviously I have a problem with the head gasket or head bolts. My head gasket came in an engine gasket kit. Maybe not one of the best. I used copper spray gasket material on it when installing. Too much? Too little? Didn't get the head bolts tight enough before I put the head on? I know I need to pull everything, and change fluids, but any idea what I did wrong? Bad enough to do it wrong once, rather not do it wrong twice.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|