Farmall & IHC Tractors Discussion Board |
Need help with pto shaft replacement on a B
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave_D on April 04, 2003 at 11:32:03 from (206.176.131.27):
I finally got around to replacing the bent PTO shaft on my 1942 B. I purchase a pto unit from a C to replace it with. Turns out, its not the same. So a simple R&R is not going to be possible. It does appear that I should be able to remove the PTO shaft from the C housing and put it into the B housing. I see the gear is pressed on to the pto shaft, does this have to come off to get the shaft out of the housing? And advice would be greatly appriciated. Did fine an interesting trick, note in the picture the string used as a gasket. It was used with silicon also. It was a good tight seal. Thanks Dave D Chico, TX
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|