Farmall & IHC Tractors Discussion Board |
banjo fittings
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Foz on March 27, 2003 at 13:14:10 from (152.163.189.203):
I posted a day or so ago bout banjo fittings and a source of them. thanks to all that offered help.I did manage to get a few good leads.....Then while looking at the fitting sitting on the bench last night I thought "all that is ,is a pile of differant sized washers with a tube out the side!" So...after digging through my washer bucket for the correct size washers, I put them in the order I thought would work and welded them together. tapped a hole in the side for a tube. cut a groove on each face with a hole saw to accept an O ring , and wallah! After some cleaning up and installation the dang thing actually holds pressure! At least for the 15 minutes I ran it. I geuss time will tell! But at least I didn't have to wait for one to come in the mail!
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|