Farmall & IHC Tractors Discussion Board |
Re: Hammer mill Farmall H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Okla/Kans Bill on March 18, 2003 at 16:08:52 from (209.240.198.63):
In Reply to: Hammer mill Farmall H posted by Scott in MO on March 17, 2003 at 19:49:33:
I forgot, to say that when you belt it up, and if it is the type of mill I suggested above, You will need to give yor belt a double spin, er, twist it twice. When you start it up, do it slow, look inside. the hammers should be turning away from the feed table, not toward it. While runing slw, grease it. Then slowly up the speed to wide open and feed it to it. When you hear the grinder start to bog down, quit feeding and let the tractor rebuld back to normal operating speed. After awhile, you will learn to keep a steady flow of grain going into it with alot of little fluctations, but not no big ones. With a mill like nmine, you have to dribble the corn in cause thefeed table opening to the mill is s small that it wont allow alot of feed to go in at any one time
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|