Farmall & IHC Tractors Discussion Board |
Re: Threads stripped in block - help!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on March 18, 2003 at 10:35:44 from (63.147.130.30):
In Reply to: Threads stripped in block - help! posted by Bruce on March 16, 2003 at 13:48:47:
You will have to remove the head to seak repair. Did the threads pull off of the stud? Or did the threads pull out of block? You should be able to tell by looking at the stud that pulled out. If the stud still has its threads on it, then you damaged the block threads. If the stud threads are gone (more likely than not) then you probably done more damage to the stud then the block. In this case (and maybe try it anyways) try to retap the block threads and try a new stud. You will have to retap to clean out the threads off the stud that are left in there. Otherwise you will have to drill and use a helicoil or something of that nature.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|